Launch cheapest scan tool,is it worth to buy ?

Well today we talb about the best cheapest obd2 scanned tool for do-it-yourself guys and as you can see inside here.

I have boxes and boxes of scan tools, so I tested out a whole bunch of them and as far as I’m concerned this Creader 3001 $23.99 scan tool is the best cheapest one for do-it-yourself guys, it’s easy to use you just plug it into the OBD port down here then just turn the key on.

so the engine lights are on but the car isn’t running and it automatically sets itself up we’ll click diagnose, there it is reading a computer of your car and it’s already figured out what car it is you don’t have to input anything and you can start reading the data and as you can see you can read codes you can erase codes you can see if it’ll pass the emissions test.

For yearly state inspection, you can get live data stream you can do freeze-frame when there’s a trouble code to figure out what’s wrong you can even do an oxygen sensor test and on this older Toyota it does 38 different points of data so you can analyze what’s wrong with your car, you can read main sensor data and fuel trim data to see if the car is running rich or lean and on this car you can even do the vapor pressure to see if you have a problem the evap anti-pollution system and of course if your check engine light is on.

it can read the codes in this case it’s reading the code now it’s got P0507 it explains what the code is in this case the idle air control system the RPM is higher than expected and then it can show you the freeze frame data of when that code was stored here we go here’s all the data of when the freeze frame was stored so you can analyze it and find out what the problem is and of course once you fix it.

you could turn the trouble code off, here we go now it’s erasing the codes it’s doing its little job takes a few seconds and now the code has been cleared and if you check it, it’ll show there are no codes we’ll check read codes again to make sure it worked.

now it’s thinking, and there it is there’s no trouble codes it’s erased them, all in all ,it’s a pretty good tool for only $23.99 it’s made by a company launch, it’s been around a long time, so it’s not like it’s some new company that’s messing with new software because many of the cheaper scan tools that I tried out they didn’t even work when you plugged it in or you plug it in.

Link to buy here : Launch Creader 3001